Yoko
http://forum.yoko.com.ua/

Quantity on OnGump.
http://forum.yoko.com.ua/viewtopic.php?f=3&t=11777		 Page 1 of 1
Author:  Aldebaran [ 2007-04-17 15:26:05 ]
Post subject:  Quantity on OnGump.
Hi all:

I would like to know if it is possible to set quantity in an entry, when using "ongump" command. I mean, if there is any way to set I want make 10 chairs through use of OnGump command.

Thank you in advanced!
Author:  Nmy [ 2007-04-17 15:47:53 ]
Post subject: 
Code:
VAR i
for i=1 to 10
uo.ongump('whatever')
wait(5000)
next
Author:  Aldebaran [ 2007-04-17 16:03:19 ]
Post subject: 
Thank you, Mr Nmy:

But what I am looking for is the correct use OnGump command, since I can't write "entryes" parameters correctly.
If I write:

,ongump anygump 210 entryes

system says it is correctly parsed. But when I write this:

,ongump anygump 210 entryes '10'

systems says parameter "entryes" is incorrect.

and I wonder why :lol:
Author:  Nmy [ 2007-04-17 18:29:14 ]
Post subject: 
Aldebaran wrote:
Thank you, Mr Nmy:

But what I am looking for is the correct use OnGump command, since I can't write "entryes" parameters correctly.
If I write:

,ongump anygump 210 entryes

system says it is correctly parsed. But when I write this:

,ongump anygump 210 entryes '10'

systems says parameter "entryes" is incorrect.

and I wonder why :lol:


well I dont use ongump and I think entryes is for text use only
Page 1 of 1 All times are UTC+02:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/